The Surfboard Studio - Quick Cure, 5 min. Two Part Epoxy Repair is a remarkable, rapid setting repair system. The two part liquid epoxy adhesive has a rapid 5 minute cure time, perfect for those smaller dings. The two part, 1:1 ratio makes it easier than any previous mixing system and keeps it simpler for application. The Quick Cure epoxy can also be used in conjunction with Q-Cell and Cabosil fillers to create a thickened glue paste. With an almost endless shelf life, keep a pack handy for a better surf.

DIRECTIONS

Resin should be mixed in a clean plastic disposable container or measuring jug. Resin should be measured by volume only.
Important - Accurately measure resin and hardener for optimum performance.
Ideal resin temperature is 18-25°c or room temperature.
Mix PART A: Epoxy Adhesive with PART B: Epoxy hardener at a ratio of 1:1
Mix slowly for approx. 30 seconds, ensuring not to create excessive air entrapment.
Resin pot life will be approx. 5 mins. when mixed at a ratio of 1:1.
To reduce viscosity in colder climates, put bottles in warm water for 5 minutes.
Can be used in conjunction with Q-Cell and Cabosil fillers to create a thickened glue paste.
5 min Epoxy can be mixed with solid and translucent tints.
When using with woven fibreglass, use a squeegee to wet it out.

HANDLING AND SAFETY

Use in a ventilated area.
Wear PPE safety equipment; gloves, face mask, safety glasses.
If resin or hardener comes into contact with skin or clothing, remove contaminated clothing and wash skin with cool water.
Dispose of all resins as per your council regulations for hazardous material.
Ambient temperature and resin temperature will effect geltime and curing properties.
The end user must test material before any application to ensure correct compatibility of the resin.
Keep out of reach of children.
Keep away from heat, sparks, open flames or hot surfaces.
Keep containers tightly closed.
Ground bond container and receiving equipment.
Do not breathe fumes.
Wash hands after handling.
Do not eat, drink or smoke while using product.
Avoid release to the environment.
Wear protective clothing.
Store locked up, in a cool, dry place.
This product and residual vapours may be flammable.

FIRST AID

If swallowed DO NOT induce vomiting, rinse mouth with water and give a glass of water or milk.
If vomiting occurs, keep patients head down to prevent vomit entering lungs.
If splashed in eyes, flood with low pressure water for at least 15 minutes.
If splashed on skin remove contaminated clothing and gently wash with mild soap and water. If irritating or swelling occurs, seek medical attention.
Always seek medical attention or contact Poison Information Centre.

Blog posts & pages